Because of this, when SFP port 15 is used, RJ-45 port 15 cannot be used, and vice versa. These ports share the numbers 15 and 16 with RJ-45 ports. Two of the physical ports on the FortiGate-100D (Generation 2) are SFP ports.
As shown below, the FortiGate-100D (Generation 2) has 22 interfaces. They also appear when you are configuring the interfaces, by going to S ys t e m > Network > Interface. In FortiOS, the port names, as labeled on the FortiGate unit, appear in the web-based manager in the U n i t Operation widget, found on the Dashboard. Some units have a grouping of ports labelled as internal, providing a built-in switch functionality. Depending on the model, they can have anywhere from four to 40 physical ports. If the prios differ, you've got a backup link.FortiGate units have a number of physical ports where you connect ethernet or optical cables. If you set the distances equal and equal priorities then you have load balancing over both links at the same time. If you want the second link to only become active after failover then you would set the distance higher than on the primary link, not the priority. All Dead Gateway Detection settings in one place, targets can be pinged or HTTP-getted and more. If you already use v5.2.2 then create a Virtual WAN link with wan1, wan2. *** NEVERMIND, FOUND THE DEAD GATEWAY ECMP FEATURE UNDER System > Router > Static Route > Setting > Create New I am using a Fortigate 100D and v5.0 and the Dead Gateway Detection is not present on System > Network Interfaces. How can I configure the firewall to automatically failover?
I am asking if the provider link is not hard down, but their internet service is **** (re-route or next hop down within the provider).
0 kommentar(er)
